Search results for "BORATE BUFFER"
showing 4 items of 4 documents
Identification of passive layers on Co in Alkaline solutions by photocurrent spectroscopy
2005
The photoelectrochemical behavior of passive films on Co has been studied as a function of the polarizing voltage and electrolyte composition. Passive layers formed at 0 V (standard hydrogen electrode, SHE) in 0.1 M NaOH consisted of Co(OH) 2 , whose bandgap value has been found to be 1.85 eV. Higher bandgap values (2.75 eV) have been measured for passive films formed in borate buffer at 0 V (SHE), which are mainly consist of CoO. The Eg values have been related to the film composition on the basis of a correlation between the bandgap of passive films and the electronegativity of their constituents.
Effect of temperature on the passive state of Alloy 31 in a LiBr solution: Passivation and Mott-Schottky analysis
2015
The passive behaviour of Alloy 31, a highly-alloyed austenitic stainless steel (UNS N08031), has been investigated in a LiBr heavy brine (700 g/l) at different temperatures using potentiostatic polarisation and Mott-Schottky analysis. Cation vacancies have been found to be the dominant defect in the passive films formed on Alloy 31. An increase in temperature enhanced the generation of cation vacancies at the film/solution interface and raised the steady-state passive current density. The density of defects within the passive film also increased significantly with temperature, making the film more conductive and less protective against localised attacks.
Micellar electrokinetic chromatography of polyamines and monoacetylpolyamines
2001
A selective procedure for qualitative and quantitative analysis of ten polyamines by micellar electrokinetic chromatography (MEKC) was developed. Benzoylated polyamines and acetylpolyamines in micellar phase of SDS (10 mM) were separated at 25 degrees C by 20 mM borate buffer pH 8.5, containing 8% ethanol, with an applied voltage of 25 kV (5 microA) and then detected at 198 nm. The experimental factors and operational parameters were optimized by performing analysis at different surfactant concentrations, pH, voltage and temperature with and without ethanol. The repeatibility of migration times and peak heights is a peculiarity of the method here described.
Ruthenium red staining of polyanion containing structures in sections from epoxy-resin embedded tissues
1984
Summary Staining by ruthenium red (0.5 mg/ml in borate buffer at pH = 9.2) has been used for light and electron microscopic visualization of polyanion containing structures in sections from glutaraldehyde-fixed, epoxy-embedded tissues. This staining technique can be applied in a simple and rapid way, showing the reactive cell components with suitable resolution and contrast. Preliminary spectrophotometric studies show the correspondence in absorption characteristics of the dye which is bound to polyanions in situ or in vitro .